Seite 1 von 1

industa 300

Verfasst: Fr Mär 20, 2009 6:28 pm
von FoxVK
Hello

I want to make regulator for this soldering iron by myself.

How this station measure temperature? by thermocouple ? AND to which pins is it conected to ? 1-2 ?
Bild(male connector on the cable)

Thanks you.

Verfasst: Mi Mär 25, 2009 11:40 am
von Herbert Schmidt
Hello,

the Industa 300 has no thermocouple in the soldering iron.

The temperature is controlled by the analysis of the signal for the phase controlled modulator, which regulates the power to the soldering iron.

Pin 1 and 3 are connected to the heating element in the iron.
Pin 2 is not connected.

For you own regulator you will have now temperature signal availbale.

Best regards

Herbert Schmidt